Odyssey 7Q User Manual - page 4
PANASONIC LUMIX GH4
5. SET CLEAN HDMI OUTPUT
MENU »
(4) » HDMI REC OUTPUT » INFO DISPLAY » OFF
** Note that 4K and 1080p50/60p over HDMI is only supported on the Odyssey7Q+
1080p50/60 is supported on any Odyssey with the use of a HDMI to SDI converter.
CAMERA SETTINGS (YAGH OUTPUT)
This section covers the use of the GH4 with the YAGH Interface (
Panasonic DMW-YAGH
).
1. CONNECT THE YAGH TO THE CAMERA
2. CONNECT THE ODYSSEY TO THE YAGH
VIA HDMI
Connect the HDMI output from the YAGH to the HDMI input of the Odyssey.
VIA SDI
Connect each of the four BNC outputs on the YAGH to the SDI ports on the Odyssey
SDI OUT 1 » SDI A IN
SDI OUT 2 » SDI B IN
SDI OUT 3 » SDI A IO
SDI OUT 4 » SDI B IO
3. SETUP THE YAGH FOR TRIGGERING VIA SDI
MENU then Motion Picture then Interface unit and set SDI Remote Recording to ON
MENU »
(1) » INTERFACE UNIT» SDI REMOTE RECORDING » ON
4. SET 4K DOWN CONVERT (IF YOU ARE RECORDING HD)
When using the YAGH for HD Recording you must set the 4K down convert to 1080p.
MENU »
(4) » HDMI REC OUTPUT » 4K DOWN CONVERT » 1080P
3