Odyssey Galaxy Seeker II Instruction & Reference Manual - Notice
MICRO SD
CARD
LCD Screen Capabilities
VIEW
REC
SNAP
DOWN
UP
View the videos & pictures in memory
Press this button to begin recording
Press this button to take a picture
Decrease monitor brightness
Increase monitor brightness
USING THE ONBOARD MONITOR TO RECORD VIDEO & TAKE PHOTOS
NOTICE
The Galaxy Seeker II battery comes partially charged and is ready to fly.
Skip to Remote Control Battery Installation section and use your Seeker
now. Use this charge completely before charging the Galaxy Seeker
battery for the first time.
WE RECOMMEND!
When charging with the included USB cable, the LED light will light up red,
indicating it is charging. Once charging is complete, the LED light will turn
off. Discontinue charging immediately.
Step 3: While powered on and in flight, use the Photo or Video button to take pictures or create thrilling aerial footage.
• Press REC to begin recording and REC again to stop recording. Note: You must have an SD card installed in order to record.
• Press SNAP to take a photo. The Eclipse onboard camera requires a couple of seconds between photos.
Optimal Video Performance
The Galaxy Seeker II’s built-in HD camera will provide live video up to a range of 164 feet (50 meters).
Video performance may become erratic after 50 meters.
Replaying your videos and photos:
You can replay your videos and photos anywhere, even in the field! Just remove the MicroSD card from the Drone and install the
card in the slot on the bottom edge of the included monitor.
You can also replay your videos and photos with a compatible tablet or computer.
Step 1: Turn the Drone over and set it down on a soft, stable surface.
Step 2: Slide a MicroSD card into the monitor housing until it clicks into place.
3. Connect the battery’s power cable to the end of the USB charging cable, the one with the red and black tip. Then connect the USB end of the charging cable to a
USB charging port. Please note: Not all USB ports provide power. Typically, only ports mounted on a computer and not through a peripheral will provide enough
power for charging. After charging the battery, disconnect the USB cord and carefully, without pulling on the internal wires, reconnect the battery cord with the
connector inside the battery compartment of the Drone.
4. Charge the Galaxy Seeker II monitor by using the separate USB cable supplied.
Rechargeable Lithium
Polymer Battery
3.7V / 700 mAh
The Galaxy Seeker II is equipped with a full 720p, wide-angle lens that will provide a great First Person View. It’s like being in the cockpit!
Micro SD Card Slot