Odyssey Galaxy Seeker II Instruction & Reference Manual - Notice
4
ASCEND
DESCEND
FLYING,
DIRECTIONS,
& TURNING
GOING TO FLIGHT SCHOOL • CONTROLLING THE GALAXY SEEKER II UNIT
PAIR THE UNITS & START TO FLY
ADVANCED FEATURES • ALWAYS-ON AUTO HOVER & 360º FLIPS
Ease the throttle (left
stick) upward in order
to make the Galaxy
Seeker II go higher.
Ease the throttle (left
stick) downward in order
to make the Galaxy
Seeker II lose altitude.
Use the right stick,
(Directional Stick) to turn
left, right, move forward or
backward. Normally, the
Galaxy Seeker’s II’s “front”
is the cockpit.
Pressing Right or Left on
the Throttle stick will
strafe in that direction
according to the cockpit.
360
º
FLIP
Press the 360 button once on the
bottom right of the radio control
transmitter to have it perform 360
º
flip maneuvers!
ALWAYS-ON AUTO HOVER
Your Galaxy Seeker II Drone features an Always-On Auto Hover mode. Just
launch the Drone into the sky, take it up to your desired altitude using the
left joystick and then release the joystick. The Galaxy Seeker II will stay at
the desired altitude without further commands needed.
Step 1: Switch on the Drone. The LED lights will start to blink.
Step 2: Turn on the Remote Transmitter. Its power light will illuminate. Wait 7 seconds for the electronic gyro to stabilize*.
Step 3: Push the throttle (left) stick up to the 12 o'clock position and then down to the 6 o'clock position. As the remote transmitter
searches for the Drone, the power light on the transmitter blinks rapidly.
Step 4: Connection is complete once the power light and the LEDs on the Drone stop blinking. You're ready to fly!
Be sure to place the quadcopter on a level surface to ensure a proper and neutral alignment of the gyro.