Odyssey ODY-1717NX Instruction Manual - Caution:
Charging the Pocket Drone Battery
Please Note: The Pocket Drone comes
with a partially charged battery, however
in the case that you need to charge the
battery please follow the instructions
below.
Step 1 On the back of the drone push
the drone’s battery lid up until it clicks.
Then lift it up and push it back until it
clicks again into place.
Step 2 Carefully remove the battery and
disconnect it from the drone by lightly
pulling on the black and white port.
Important: Do not pull on the wires to
remove the battery as this may damage
the battery.
Step 3 Insert the white connector of the
battery into the USB.
Step 4 Insert the USB into a computer.
A red light will appear on the USB
indicating the charge has started.
Step 5 The charge is complete when the
red light disappears. Remove the USB
from your computer and the battery from
the USB.
Step 6 Insert the battery into the drone
by connecting the white port to the white
circuit and replace the lid by folding it
down and pushing backwards until it
clicks.
Warning: Please check the batteries
regularly as potential leakage and/or
corrosion of old batteries can damage
the drone and/or create a fire hazard.
Caution:
• Remove the batteries immediately if
you sense any smell or smoke.
• Do not charge the batteries if they are
hot, wait until they cool down.
• Do not charge the batteries next to
inflammables or on a conductive
surface.
• Do not overcharge the battery, once
the red light disappears, discontent the
battery.
• Do not use non-Odyssey batteries and
battery chargers. Only use those which
come packaged with this device. If you
need additional batteries or chargers,
they are available in our Parts Shop on
www.odysseytoys.com.
• For safety and best practice, unplug
the battery connection from the power
source inside the drone when not in
operation.
7