Odyssey ODY-1717NX Instruction Manual - Downloading The
Charging the Pocket Drone Battery
Please Note: The Pocket Drone comes
with a partially charged battery, however
in the case that you need to charge the
battery please follow the instructions
below.
Step 1 On the back of the drone push
the drone’s battery lid up until it clicks.
Then lift it up and push it back until it
clicks again into place.
Step 2 Carefully remove the battery and
disconnect it from the drone by lightly
pulling on the black and white port.
Important: Do not pull on the wires to
remove the battery as this may damage
the battery.
Step 3 Insert the white connector of the
battery into the USB.
Step 4 Insert the USB into a computer.
A red light will appear on the USB
indicating the charge has started.
Step 5 The charge is complete when the
red light disappears. Remove the USB
from your computer and the battery from
the USB.
Step 6 Insert the battery into the drone
by connecting the white port to the white
circuit and replace the lid by folding it
down and pushing backwards until it
clicks.
Downloading the
Odyssey Application
Notice: The Pocket Drone quadcopter
transmitter is application based and you
must download the app to fly the drone.
The app is supported on Android and
iOS devices.
Step 1 Use your phone to scan the QR
code or install the app by accessing the
Play/iTunes store and searching for
ODY Pocket Drone.
Step 2 Press the power button on your
drone, the lights will flash.
Step 3 Connect your phone to the
drone’s Wi-Fi signal named
Pocket Drone 2
Step 4 Open the app and tap Connect.
This will connect your drone to the
application.
8