Officezone RHIN-O-TUFF OD 3500 Instruction Book - page 11
holes in the sheets or covers. Continue until the coil is past the left side of
the book by about one or two coils.
Diagram 2d
i)
Drive wheel stop screw.
The drive wheel
stop screw (12)
will prevent the wheel from pressing to
hard on the mandrel. It is very important not to have too much pressure on
the mandrel when inserting the larger coils. If the leading edge of the coil
stops on a misaligned sheet, the coil wants to tie itself into a knot between
the book and the end of the mandrel. Setting the stop screw will prevent
this from happening most of the time. To set the stop screw, turn it
clockwise to push the wheel away from the mandrel. Load the coil onto the
mandrel and turn the stop screw counter clockwise while holding down on
the motor
handle (10) until the drive wheel touches
the coil. Try a few
books and readjust if necessary.
If the mandrel bracket is adjusted after the stop screw has been
adjusted, it will be necessary to readjust the stop screw.
j)
Cutting a coil
There are special cutter crimper pliers (ordered separately) that are used
to terminate the ends of the coil. After the coil is cut, the sharp end of the
coil will tuck itself under the inside of the coil opening. To use the cutter,
make sure the red dot (13) is facing up. Place the cutter on the
1-800-543-5454
OfficeZone