Officezone RHIN-O-TUFF OD 3500 Instruction Book - page 9
Diagram 2a
a)
Adjusting the paper stop.
Place the book on top of the Combo Binding Station or the OD 4000 Punch
with the right side of the book against the paper stop bracket. Adjust the
paper stop (6) so the holes of the book hang over the edge of the Combo
Binding Station or OD 4000 Punch. The
holes should hang over the edge
just enough for the coil to clear the edge of the Combo Binding Station
or the OD 4000 Punch.
Tighten the knob located on the paper stop bracket.
It may be necessary to fine-tune this after a few books are bound for exact
placement.
f)
Adjusting the front table / lexan guide
The
front table/ lexan guide (7,7a & 7b)
has two purposes. (FIRST):
When the lexan is in the closed position, rotated on top of the coil (7a), it
will assist the coil to insert smoothly into the book. You should use the
lexan guide with all books regardless of thickness. (SECOND): With the
lexan guide (plastic) in the open position,
away from the
machine, it acts as a support table (7b) for large books. For book’s over
9/16" thick, it may be necessary at times to start the coil into the book,
then split the book in half using the table to support one half of the book,
then finish the inserting of the coil. This method improves productivity.
Diagram 2b
1-800-543-5454
OfficeZone