Offshore 3185 User Manual - Installation
INSTALLATION
2
3 of 12
2.1 Unpacking the box
You should find the following items in the 3185 shipping box:
1 x 3185 J1939 to NMEA2000® Adaptor
1 x Din Rail mounting Kit with 2 rail mounts and 4 countersunk M3 screws for rails
1 x 3185 User Manual (This document)
2.2 Mounting the unit
The unit can either be mounted to a flat surface using 4 mounting screws. The unit dimensions
and mounting hole locations are shown on the following drawing.
Or the unit can be Din Rails mounted by attaching the Din Rail mounts to the case using the
supplied M3 CSK screws and then clipping the unit to the Din Rail
2.3 Connecting the NMEA2000® Cable
The unit is connected to the NMEA2000® network by the 5 way micro C socket on the front.
Carefully attach the network drop cable to this plug and hand tighten until it it is fully seated.
Take care to match the orientation of the pip inside the socket to the recess inside the drop
cable plug. The other end of the drop cable should be connected to a suitable Tee connector on
the NMEA2000® network backbone cable.