Oki C610dn Installation Instructions Manual
1
English
1 Install the Duplex
Unit
The duplex unit slides straight
into the rear of the printer and
requires no tools to install.
1. Take the duplex unit out of its
package and remove any
shipping materials.
2. Switch the printer off. (No need
to disconnect the power cable.)
3. Ensure that the duplex unit is the
right way up, as shown, and
push it into the slot on the back
of the printer. The slot cover will
swing inwards as you push the
unit in.
Important!:
Be sure to push the
unit all the way in until it stops
and latches home.
2 Confirm the
Installation
Examine the top of the first
page of the configuration
report. It should indicate that
the duplex unit is now installed.
To print the report:
1. Switch the printer on and wait
for it to warm up (about 1
minute).
2. Press the Enter key.
3. Press the down key.
Print Information displays.
4. Press Enter.
Configuration, Execute
displays.
5. Press Enter.
The report prints and the
printer goes back on line.
3 Engage Duplex
Printing in the
Printer Menu
Note:
To do this you must have
administrator privileges.
1. Press Enter.
2. Press the down arrow key until
Admin Setup displays.
3. Press Enter.
4. Enter the password (default
password is aaaaaa).
5. Press Enter.
6. Press the down arrow key until
Print Setup displays.
7. Press Enter.
8. Press the down arrow key until
Duplex displays.
9. Press Enter.
10.Press the down arrow key to
change the setting to On.
11.Press Enter.
12.Press OnLine.
4 Activate the
Duplex Unit in the
Printer Driver
Windows
®
Note:
Remember that if your
printer is shared between
users on different comput-
ers, the driver must be
adjusted on each user’s
machine.
1. First, open the Printers (Printers
and Faxes) dialog box:
a.
Windows 2000:
Click Start > Settings >
Printers.
b.
Windows XP, Server 2003:
Click Start > Settings >
Printers and Faxes.
c. Windows Vista, Windows
7:
Click Start > Control Panel >
Printers.
2. Right click the printer icon and
choose Properties.
3. In the PS driver, click the
Installable Options tab.
In the PCL driver, click the
Device Options tab.
4. In the PS driver, scroll to
Installable Options and select
options.
In the PCL driver select the
appropriate check box in
Available Options.
5. Click OK.
6. Close the dialog box.
Macintosh
®
Note:
This is required for IP and
Bonjour connections only;
USB and AppleTalk connec-
tions are normally configured
automatically.
Optional Duplex Unit
English . . . . . . . . . . . 1
Español . . . . . . . . . . . . 5
Français . . . . . . . . . . 3
Português . . . . . . . . . . 7
Installation Instructions