Oki OKIFAX OF-38 Field Service Manual - page 42
Item
Specifications
77
Transmission Document
The documents must be rectangular in shape, and must
be placed face down on the ADF stacker.
1) Thickness
a)
0.13
b)
Up to 0.15 mm/single sheet
2) Shape
Documents must be rectangular in shape.
3 ) O p a c i t y
Documents must not permit more than 40% of the
scanner source light to pass through them.
4) Document skew
Maximum 2.6 mm skew over length of
A4
the documents are loaded correctly.
5) Document stacking
Documents up to 356 mm in length, which meet the
basis weight and thickness specification.
78
Document Jam Detection
1)
When the end of document is not detected within
445 mm after scanning begins (except if unlimited).
2)
When the document does not reach the scanning
position within 5 seconds after the start of a
document feed.
Note:
When a jam is detected during message
transmission, the machine will stop, but its
receiving capability will remain valid. Should a
call arrive under this condition, the OF-38 will
print out the received message without paper
cutting function, because of the document feed
motor (which is used for paper cutting during
message reception) out of function.