Oki T400 Installation Manual - Installing The Dispenser Kit
Other manuals for T400:
Safety Information Manual, Install Sheet, Setup Manual, User Manual, Installation
Manual is about: T400/T410 User Guide
of
12
Page 4
Installing the Dispenser Kit
LINE UP EDGE OF GUIDE
SHEET AND NOTCH
PRESS DOWN TO ATTACH
TO FRONT DOOR PANEL
PEEL BACKING
PAPER FROM GUIDE
SHEET
STEP
PROCEDURE
9.
Remove the backing paper from the Guide Sheet. Line up one side of
the Guide Sheet (match notch on Guide Sheet with notch on Front Door
Panel). Press down firmly to attach.
10.
Attach connector from the Dispenser Kit to CN13 on the printer as
shown.
11.
Position the Dispenser Kit with the printer so that the locating pins of
the printer line up with the holes on the Dispenser Kit.
12.
Secure with two screws provided.
13.
Set the dip switch settings to the dispenser mode.
1
W
S
D
2
W
S
D
3
W
S
D
G
N
I
T
T
E
S
n
O
n
O
f
f
O
e
d
o
M
r
e
s
n
e
p
s
i
D
Direct Thermal Unit