Oki X400 Installation Manual - C. Reassemble The Printer
Other manuals for X400:
Safety Information Manual, User Manual, User Manual, Assembly Instructions, Install Sheet, Manual
Manual is about: X400 Programming Command Manual
of
8
4
2. Orient the memory card properly, and insert it into the expansion slot as shown in pic5 below. The
copper colored heat sink will be partially covered by the memory card.
NOTE: It is NOT necessary to change any of the jumpers on either the memory card or the main circuit
board. Simply insert the card and leave the jumpers as they are.
C. Reassemble the Printer
Reassemble the printer by reversing the steps in section A, being careful not to pinch any cables.
D. Print a Self Test
Print a self test to confirm that the card has been properly installed.
To do this, hold in the purple feed button, and turn on the printer.