P+S Technik Weisscam HS-1 Operator's Manual - page 36
E|14
Window : Camera Convert Control
Set your
White Balance
in this window
Open window
Convert Control Color
->
If you are in
Live Preview
or
Recoding
mode the
changes may react slowly, because through Firewire informa-
tion can only be send in one direction at a time.
Use ONLY RGB Balance. Do not use Color Balance.
Check if
Gain
value is down.
Gain
affects all three RGB curves at the
same time. Use
Gain
carefully and no more than two steps, it‘s better
to use more light sources. High Gain values will increase noise in the
image.
Find the appropriate white balance with moving the RGB curves care-
fully with the little red arrow at the top of the curves. The little red arrow
at the bottom of the RGB curves should not to be below 25.
Check your white balance by moving the cursor into a white area in the
image and control the RGB values in the main window’s status line.
They are fine if the three colors have about the same values.
You can try AUTO White Balance, but normally the result is not satis-
fying. Results are better if adjusted manually.
1.