Paccar PX-9 Operator's Manual - page 69
MAINTENANCE SPECIFICATIONS
NOTE
If the type/oil capacity of each lubri-
cating oil pan is not known:
•
Contact a PACCAR®
Authorized Repair Location.
•
Determine the capacity of
the oil pan option for the
engine being serviced by using
QuickServe™ Online and the
engine serial number.
•
Fill the lubricating oil pan to
the smallest oil pan capacity
listed for the engine being
serviced. Then add 1 qt (0.95
liters) of oil at a time until it
reaches the high mark on the
dipstick. Record the number
of liters/quarts added, so the
capacity is known the next
time the oil is drained.
Cooling System
Coolant capacity
(engine only)
16.5 qt (15.6
liters)
Standard
modulating
thermostat range
180 to 200°F (82
to 93°C)
Minimum
recommended
pressure cap
13 psi (90 kPa)
Maximum top
tank coolant
temperature
225°F (107°C)
Minimum fill rate
(without low-level
alarm)
3 gpm (11.4
liters/minute)
Maximum
deaeration time
25 minutes
Maximum top
tank coolant
temperature
225°F (107°C)
Winterfronts —
Minimum allowed
air passage area
120 in.² (774 cm²)
WARNING!
Coolant is toxic. DO NOT get the
fluid in eyes.
If contact with the
eyes occurs, flood eyes with large
amounts of water for 15 minutes.
Avoid prolonged or repeated con-
tact with skin. In case of contact,
immediately wash skin with soap
and water.
DO NOT take inter-
nally. If swallowed, seek immedi-
ate medical attention. DO NOT in-
duce vomiting. Failure to comply
may result in death, personal in-
jury, equipment or property dam-
age.
(12/2014)
Y53-1185-1B1
5-15
5