Pace RNG110 Installation Manual - Operating The Set-Top
17
RNG110 INSTALLER’S MANUAL (501-3438010)
OPERATING THE SET-TOP
Turning the set-top on and off
After you have connected the set-top’s power supply unit to the wall AC outlet (and switched this outlet ON, if it
has a switch), press the
POWER
button on the remote control to turn the set-top on (making sure the remote
control is set to control the set-top). The
POWER
light on the set-top’s front panel should light up green, to
show that the set-top is on.
To turn the set-top on or off at any time, press the
POWER
button on the remote control.
Never turn off the set-top by simply disconnecting it from the power supply. If you need to disconnect the
set-top, turn off the set-top by pressing the
POWER
button on the remote control, so that the
POWER
light is
switched off. Then wait a few seconds before disconnecting the power supply unit from the wall AC outlet.
Power Saving: To save power and money, and to reduce greenhouse gas emissions, turn off
the set-top, using the POWER button on the remote control, when it is not in use.
Using the remote control
Your cable TV service-provider determines the digital channels, services, and screen information that you see
on your TV when you use the set-top and its remote control.
Consult the information supplied by your cable service-provider for details on how to make the most of the
digital cable services. Also read the operating instructions that are supplied with your remote control.
NOTES
IMPORTANT: Unless there is a
lightning storm or the set-top’s
users are away from their home
for a long time, do not unplug the
set-top’s power supply unit at the
wall AC outlet (or do not switch it
off there, if the outlet has a switch).
The set-top cannot be updated with
new features, through the cable, if
it is disconnected from the power
supply.