Pace RNG110 Installation Manual - Making User Settings
19
RNG110 INSTALLER’S MANUAL (501-3438010)
MAKING USER SETTINGS
About User Settings
You need to make the correct settings so that the set-top is compatible with the HDTV or TV. However, you may
wish to change some settings, for example if you purchase a new HDTV. You can make the following settings
and you can also reset them to the factory defaults.
• TV Aspect Ratio (the screen’s width-to-height ratio, or shape)
• TV Display Capability (screen resolution)
• Auto Pillarbox
• Closed Captions
• Front Panel Settings
• HDMI Settings
You use the buttons on the remote control to make the settings using on-screen menus. However, until the
set-top has been set up to match the display capability of the TV (see page 20), these menus may not be visible.
Putting the set-top into User Settings mode
1. Make sure that the set-top is turned on (
POWER
light is green).
2. Press the
POWER
button on the remote control (
POWER
light goes off), then press the
MENU
button.
You should see the PACE USER SETTINGS menu, shown right, on the TV screen.
3. When you have finished making changes (see pages 19 through 23), press the
POWER
button to remove the
PACE USER SETTINGS menu and return to normal viewing.
About the TV Aspect Ratio
The TV that you have connected to the set-top has an aspect ratio (width-to-height ratio) of 4:3 (basic/standard)
or 16:9 (widescreen). You must set the appropriate TV Aspect Ratio (4:3 or 16:9) on the set-top, so that it is
compatible with the TV.
Setting the TV Aspect Ratio
If you have not done so already, put the set-top into User Settings mode, as described above.
1. Press the
U
or
D
button on the remote control and highlight TV Aspect Ratio on the PACE USER
SETTINGS menu.
2. Press the
R
button.
The TV Aspect Ratio menu, shown below, appears on the TV screen. On the menu, the current setting
(“4:3” or “16:9”) has
>
in front of it. Also, whenever the current setting is displayed, the DATA light will be
lighted on the set-top’s front panel.
TV Aspect Ratio
4:3
>16:9
3. Press the
U
or
D
button to highlight the TV Aspect Ratio you want.
4. Press the
OK/Select
button to confirm your choice and change to that TV Aspect Ratio.
5. Press the
L
button. The PACE USER SETTINGS menu reappears.
To continue making the settings, see the next section.
POWER
light
PACE USER SETTINGS
TV Aspect Ratio
TV Display Capability
Auto Pillarbox
Closed Captions
Front Panel Settings
HDMI Settings
Restore Defaults
Select[OK] Exit[POWER]
4:3 standard TV,
EDTV or HDTV
16:9 HDTV