Pace RNG110 Installation Manual - page 26
26
RNG110 INSTALLER’S MANUAL (501-3438010)
DISPLAYING DIAGNOSTIC SCREENS
Displaying the Diagnostics Information screens
The Diagnostic Information screens provide “read-only” information about the configuration of the set-top.
This includes information on, for example, addressing, memory, current channel, status information, etc.
First of all, make sure that the set-top is connected to the TV by HDMI or composite video (RCA) connections,
and set the TV to its appropriate input.
Ensure the set-top is turned on (the
POWER
light on the front panel should be green).
To display the Diagnostics Information screens:
Press and release the
POWER
button on the remote control, then immediately (within 2 seconds) press and
release the
OK/Select
button on the remote control.
The DIAGNOSTICS DASHBOARD will then be displayed on the TV.
Note:
The bottom line on the dashboard cycles between SW Version:, Unit Addr:, and Last Poll Ack:.
From the DIAGNOSTICS DASHBOARD, you can press the
L
button to display the DIAGNOSTICS MAIN MENU.
Use the
L
button to toggle between the DIAGNOSTICS DASHBOARD and DIAGNOSTICS MAIN MENU.
To use the Diagnostics Information screens:
In both menus, use the
U
and
D
buttons on the remote control to move the on-screen arrow through the
items, then press
OK/Select
or
R
to view more information in sub-menus. Or, instead, you can use the
remote control to key in the 2-digit number of the sub-menu.
To remove a sub-menu and return to the preceding level, press the
L
button.
To remove the DIAGNOSTICS DASHBOARD (or DIAGNOSTICS MAIN MENU), and return to normal TV
viewing, press the
POWER
button on the remote control
twice
.