PACH & COMPANY AeGIS 7000 Series Installation And Programming Manual - Chapter 4
Chapter 4
SYSTEM’S OPERATION
Pach and Company
Chapter 4
Page 19
AeGIS 7000 Series
SYSTEM’S OPERATION
09/01/01
HOW TO VIEW
THE TENANT NAME.
HOW TO INITIATE A
CALL AND UNLOCK
THE DOOR FOR
VISITOR.
HOW TO EXTEND THE
TALK TIME
HOW TO CALL INTO
THE SYSTEM.
Two ways to view the tenant name:
1. Press 3 to scroll the tenant name from A to Z.
2. Press 6 to scroll the tenant name from Z to A.
Two way to initiate a call:
1. USING THE SCROLLING ELECTRONIC DIRECTORY
Step 1
Press 3 or 6 to scroll the tenant name, when the tenant name you are
intended to call is visible on the display, then press # to initiate the call. The
display shows:
then it shows:
Step 2
Press
*
to cancel the call, otherwise wait for the tenant to answer your call.
Step 3
Tenant must press 9 to unlock the door.
2. A DIRECT CALL
You must know the tenant directory number to use a direct call. The tenant directory
number can be associated with apartment number, suite number, etc..
Step 1
Press # and wait for a dial tone, the display shows:
Step 2
Press the 2, 3 or 4 digit directory number, the system will initiate the call.
Step 3 Press
*
to cancel the call, otherwise wait for the tenant to answer your call.
Step 4
Tenant must press 9 to unlock the door.
The talk time can be programmed from 10 - 180 seconds. You will hear “ One Long
Beep” ten seconds before the talk time expires. The tenant must press #
immediately to extend the talk time to another cycle. For example: if the talk time is set
for 30 seconds, pressing # will extend for another 30 seconds. You can continue press-
ing the # to extend the talk time after the “ One Long Beep”.
The AeGIS 7000 will accept an incoming call from tenant and tenant can talk to his or
her visitor. Function Code 74 (Enable or Disable Auto Answer) must be set to 1.
The feature is very useful if for some reason you are not available to answer the visitor
call and you can call into the system later on. This feature is not available if multi
systems are installed on a single phone line.
Step 1
Call the system ( you must know the phone number) then you hear “One Short
Beep” if the call is connected.
Step 2
Press
*
to talk to the visitor then press 9 to unlock the door or hang up.
WAIT . . . DIALING
Wait for Answer
DIR CODE: