PACH & COMPANY AeGIS 7000 Series Installation And Programming Manual - Chapter 5
Chapter 5
TROUBLE SHOOTING GUIDE
NO AUDIO WHEN
KEY(S) IS PRESSED
NO DIAL TONE WHEN
THE # KEY IS PRESSED
THE VISITOR CAN'T
HEAR THE TENANT
FROM THE SYSTEM
BUT THE TENANT CAN
HEAR THE VISITOR
THE TENANT CAN'T
HEAR THE VISITOR
TALKING BUT THE
VISITOR CAN HEAR
THE TENANT
THE LIQUID CRYSTAL
DISPLAY (LCD) SHOWS
QUESTION MARKS
(????)
THE LIQUID CRYSTAL
DISPLAY (LCD) IS
BLANK, NO DISPLAY AT
ALL
• Check the speaker and microphone connection on the board. The snap on
clip connector on the speaker and microphone connector must be facing
inside the board.
• Check the red and orange wires, make sure they are soldered into the
speaker.
• Turn the power "OFF" and disconnect the speaker connector from the board.
Set your meter to Ohm and use 50 Ohm scale or higher. Put the two probes
into the speaker (+) and (-) (polarity not important) and the meter should read
between 19 - 24 Ohms.
• Check the phone line using a standard phone, make sure you get dial
tone.
• Check the speaker and microphone connection. The snap on clip connector
on the speaker and microphone connector must be facing inside the board.
• Check the red and orange wires, make sure they are soldered into the
speaker.
• Turn the system's power "OFF" and disconnect the speaker connector from
the board. Set your meter to Ohm and use 50 Ohm scale or higher. Put the
two probes into the speaker (+) and (-) (polarity not important) and the meter
should read between 19 - 24 Ohms.
• Check the speaker and microphone connection. The snap on clip connector
on the speaker and microphone connector must be facing inside the board.
• Check the red and orange wires, make sure they are soldered into the
speaker.
• Press the # key as soon as you hear a dial tone, tap your finger into the
microphone and you should hear a finger tap sound from the speaker.
• Check the speaker and microphone connection. The snap on clip connector
on the speaker and microphone connector must be facing inside the board.
• Check the brown and black wires, make sure they are soldered into the
microphone.
• Turn the system's power "OFF" and disconnect the speaker connector from
the board. Set your meter to Ohm and use 50 Ohm scale or higher.
Put the two probes into the speaker (+) and (-) (polarity not important) and the
meter should should read between 19 - 24 Ohms.
• Turn the unit power "OFF" and "ON".
• Erase the memory chip (EEPROM) using Function Code 50. If you have
trouble to log on to programming mode, press and release the square red
button then press #.
• The power LED must be "ON" (LED2 marked on the board).
• The Power Switch's toggle must be on the left position ("ON").
• Check the fuse (3 Amp 250 Volt).
• Measure the voltage on AC1 and AC2 (set your voltmeter to AC and put the
probes on AC1 and AC2), it should read within 12VAC-13.8VAC or if you use
12 VDC, the meter must read 13.5 - 14.0 VDC.
• The LCD's ribbon cable has red dots along the side. The red dots must be
facing up. It must be connected to the terminal marked number 1.
Pach and Company
Chapter 5
Page 21
AeGIS 7000 Series
TROUBLE SHOOTING GUIDE
09/01/01
AUDIO PROBLEM S
SOLUTIONS AND SUGGESTIONS
DISPLAY PROBLEM S
SOLUTIONS AND SUGGESTIONS