PACH & COMPANY AeGIS 91000CR1000 Installation and programming manual - page 21

Pach and Company

Chapter 3

Page 13

AeGIS 9000 Series 

PROGRAMMING

FUNCTION CODE

LOCAL PROGRAMMING

Step 3

Enter 16 -characters on the first segment by rewriting the existing 

message or pressing * to clear the segment and reenter the message, see 

keypad correlation on figure 3.1, press # on every character you have 

entered and press ## after the last character you have entered on each 

segment, then the display shows

Step 4

Enter 16 -characters on the second segment, by rewriting the existing 

message or pressing * to clear the segment and reenter the message, press 

# on every character you have entered and press ## after the last character 

you have entered on each segment, then the display shows

Step 5

Enter 16 -characters on the third segment, by rewriting the existing 

message or pressing * to clear the segment and reenter the message, press 

# on every character you have entered and press ## after the last character 

you have entered on each segment, then the display shows

Step 6

Select another Function Code to program different field from the table or 

press * to exit the programming mode.

Press Once

Press Twice

Press Three Times

FIGURE 3.1

s Telephone Acce

MESSAGE SEGMENT 2

ss Control . . . .

MESSAGE SEGMENT 3

SELECT PROGRAM

ENTER: _ _  PRESS #

NOTE: IF YOU INTEND TO LEAVE THE WELCOME SCREEN BLANK 

PRESS * THEN PRESS ## ON EVERY SEGMENT.

Press 0 for space (move

cursor to the right.

Press 8 then 0 for back

space (move cursor to

left)

Press * to clear all 

letters or numbers

entered