PACH & COMPANY AeGIS 91000CR1000 Installation and programming manual - page 31

Pach and Company

Chapter 3

Page 23

AeGIS 9000 Series

PROGRAMMING

FUNCTION CODE

LOCAL PROGRAMMING

30

ADD KEYPAD ACCESS CODE AND

CARD NUMBER (RADIO TRANS-

MITTER NUMBER)

• Add 4-digit keypad access code

and optional card number or radio

transmitter number (00001 - 65535).

• Name up to 16 characters.

• Up to three Time Zones Section

can be assigned (restricted or non-

restricted) for each code.

Step 1

Log on to programming mode (see section 3.1). The display shows

Step 2

Enter Function Code 30 then press # and the display shows

Step 3

Enter 4-digit keypad access code then press # and the display shows

Step 4

Enter the card number or radio transmitter number (00001 - 65535) (leave 

this field blank if no Card Reader installed on the system) then press #, the 

display shows

if door 2 is set for mode 1 (door control). If door 2 is set other than mode 1, 

proceed to step 6.

Step 5

Enter 1=Relay 1 (Door 1) , 2=Relay 2 (Door 2), 3=Both then press #, the 

display shows

Step 6

Enter 1-3 then press #, the display shows

Step 7

Enter the Time Zone (s) programmed on Function Code 13 (0-9) then 

press #, the display shows

Step 8

Enter 1=YES then press # and proceed to step 6 or 0=NO then press # and 

the display shows

Step 9

Enter the name up to 12 characters then press #, the display shows

Step 10 Select another Function Code to program different field from the table or 

press * to exit the programming mode.

SELECT PROGRAM

ENTER: _ _  PRESS #

NEW ACCESS CODE

ENTER: _ _ _ _  PRESS #

CARD   No

ENTER: _ _ _ _ _ PRESS#

Door 1 or Door 2

3 for both: _

TimeZone  section

3 MAX [1-3]: _

Which Time Zone

[0-9] : _

Another sction

(1=YES)  (0=NO): _

CODE HOLDER NAME

_  _ _ _ _ _ _ _ _ _ _ _

SELECT PROGRAM

ENTER: _ _  PRESS #