Pacific AMX series Operation Manual - page 155
E - 3
WAS:
“This paragraph describes the configuration of the Output Voltage Range for the Models 140, 160,
345, 360, 390, and 3120-AMX Power Sources. … A Magnetics Module ( Assembly No. 134310) is
required for the 204, 273 and 341 VAC output forms.”
IS:
“This paragraph describes the configuration of the Output Voltage Range for the Models 140, 160,
320, 345, 360, 390, and 3120-AMX Power Sources. … A Magnetics Module ( Assembly No. 134350)
is required for the 204, 273 and 341 VAC output forms.”
PAGE 97; PARAGRAPH 4.6.1 SYSTEM ARCHITECTURE
Changes due to adding a magnetics module output to the 320-AMX.
WAS:
“The 1 PHASE mode of operation is a one vector output form. … The voltage ranges of the various
transformer output forms are: VR1.5 - 0 to 204 VAC
l-n
(Models 105, 108, 140, 305, 308, 345, 360,
390, and 3120-AMX), VR2.0 - 0 to 273 VAC
l-n
(Models 105, 108, 140, 305, 308, 345, 360, 390, and
3120-AMX), and VR2.5 - 0 to 341 VAC
l-n
(Models 105, 108, 140, 305, 308, 360, 390, and 3120-
AMX).”
IS:
“The 1 PHASE mode of operation is a one vector output form. … The voltage ranges of the various
transformer output forms are: VR1.5 - 0 to 204 VAC
l-n
(Models 105, 108, 140, 305, 308, 320, 345,
360, 390, and 3120-AMX), VR2.0 - 0 to 273 VAC
l-n
(Models 105, 108, 140, 305, 308, 320, 345, 360,
390, and 3120-AMX), and VR2.5 - 0 to 341 VAC
l-n
(Models 105, 108, 140, 305, 308, 320, 360, 390,
and 3120-AMX).”
WAS:
“The 2 PHASE mode of operation is a two vector output form where the vectors are separated by 180
° and
equal in amplitude. … The voltage ranges of the various transformer output forms are: VR1.5 - 0 to 408
VAC
l-l
(Models 105, 108, 140, 305, 308, 345, 360, 390, and 3120-AMX), VR2.0 - 0 to 546 VAC
l-l
(Models
105, 108, 140, 305, 308, 345, 360, 390, and 3120-AMX), and VR2.5 - 0 to 600 VAC
l-l
(Models 105, 108,
140, 305, 308, 345, 360, 390, and 3120-AMX). Note that in the case of the Models 305, 308, 330, 345,
360, 390, and 3120-AMX, only two of the three power amplifiers are connected--limiting these systems to
producing only two-thirds of rated output power.
IS:
“The 2 PHASE mode of operation is a two vector output form where the vectors are separated by 180
° and
equal in amplitude. … The voltage ranges of the various transformer output forms are: VR1.5 - 0 to 408
VAC
l-l
(Models 105, 108, 140, 305, 308, 320, 345, 360, 390, and 3120-AMX), VR2.0 - 0 to 546 VAC
l-l
(Models 105, 108, 140, 305, 308, 320, 345, 360, 390, and 3120-AMX), and VR2.5 - 0 to 600 VAC
l-l
(Models 105, 108, 140, 305, 308, 320, 345, 360, 390, and 3120-AMX). Note that in the case of the Models
305, 308, 320, 330, 345, 360, 390, and 3120-AMX, only two of the three power amplifiers are connected--
limiting these systems to producing only two-thirds of rated output power.