1. DL manuals
  2. PACIFIC CYCLE
  3. Toy
  4. 22-PS140
  5. Owner's Manual

PACIFIC CYCLE 22-PS140 Owner's Manual

Manual is about: Bayview Swing Set PlaySafe

Summary of 22-PS140

  • Page 1

    1 ©2006 pacific cycle, inc. Owner’s manual and assembly instruction model #: 22-ps140 model name: bayview swing set manual date: march, 2009 important: keep this owner’s manual; do not discard in case you need to contact pacific cycle, inc. In the future. Should there be a change of ownership, pleas...

  • Page 2

    2 ©2006 pacific cycle, inc. To make claim under warranty, notification of such defect must be given to pacific cycle, inc. By calling the phone number below, you will be instructed on how the product or part needing replacement should be shipped postpaid to pacific cycle, inc. Customer service and a...

  • Page 3

    3 ©2006 pacific cycle, inc. Warnings and safety information o bserve all warnings and statements in order to reduce the risk of injury or death . • before you assemble the swing set , find level ground not less than 6 feet from any structure or obstruction to the swing set . Y our swing set must hav...

  • Page 4

    4 ©2006 pacific cycle, inc. Proper use this swing set is designed for use by children ages 3 to 10 under adult supervision. The maximum number of users this unit is intended for is 4 children with a maximum weight of 105 lbs each. The maximum fall height for this swing set is 74”. Single ride (i.E. ...

  • Page 5

    5 ©2006 pacific cycle, inc. Checked periodically and replenished to maintain correct depth as determined necessary for your equipment. The choice of a material depends on the type and height of the playground equipment, the availability of material in your area and its cost. (the information above h...

  • Page 6

    6 ©2006 pacific cycle, inc. Pre-assembled hardware for easier assembly, playsafe™ has pre-assembled some of the parts for you. Most of the screws and bolts should already be in place. If removal of this hardware is required for certain assembly steps, it should be replaced in its original position. ...

  • Page 7

    7 ©2006 pacific cycle, inc. 4 remove the hardware from the middle section of a leg. Match up the holes of the mid-leg and support bar and re-insert the hardware through both. Repeat the process for the opposite side and center legs. It may be necessary to pull both legs towards each other in order f...

  • Page 8

    8 ©2006 pacific cycle, inc. Slide assembly required parts: slide x1 rail/ladder leg x2 front leg x2 ladder step x2 link bar x2 proper placement: slide assembly correct location incorrect location pre-assembled parts: • the screws and bolts for the slide rail/ladder legs are inserted on the slide. Th...

  • Page 9

    9 ©2006 pacific cycle, inc. 4 locate the slide front legs and insert them into the front hand rail tubes, on the underside of the slide. Align the holes and secure with the screws, washers and lock nuts. Part ref. #: pshw24 5 slide the two ladder steps onto the legs of the slide. Align the holes and...