PACIFIC CYCLE 22-PS140 Owner's Manual - page 7
7
©2006 Pacific Cycle, Inc.
4
Remove the hardware from the middle
section of a leg. Match up the holes of the
mid-leg and support bar and re-insert the
hardware through both. Repeat the process
for the opposite side and center legs. It
may be necessary to pull both legs towards
each other in order for the holes to align
properly.
NOTE: One support bar has holes for the
slide attachment. The holes should be
positioned toward the front of the swing set.
Part Ref. #: PSHW12
SWING AND TRAPEZE ASSEMBLY
Pre-Assembled Parts
• Swing seats should be attached to the chain.
Step Illustration
Instructions Hardware
Reference
1
Hang the swings and trapeze in place from the
swing hooks.
2
Check the lock nut and bolt on the swing seat to
make sure that they are secure.
Part Ref. #: PSSH11, PSHW13