Pacific Energy MIRAGE 30 SERIES A Installation And Operating Instructions Manual - page 24
24
5055.MR30-A
110915-32
Firebox Panel Removal / Installation
Note: The burner tray needs to
be removed before installation or
removal of panels - See (“Burner
Tray Installation / Removal” on
page 25)
Removal
1. After removing the burner tray,
remove one of the side panel
clips (Figure 35). Then allow
the top portion of the side
panel to move away from the
fi rebox wall (Figure 36). When
you have enough room, remove
the panel from the stove.
2. Repeat step 1 to remove
second side panel.
Note: With both side panels
removed, there is nothing
holding the upper back panel
in place and so you must be
ready to support and remove
it at the same time as the
side panel.
3. Remove the upper back panel
by allowing it to tilt forward.
Remove (Figure 37).
4. Remove the lower back panel
by lifting it off of the pilot ledge
and pull it out of stove
(Figure 38).
Installation
1. Insert lower back panel so that
it is sitting on the ledge at the
back of the fi rebox (Figure 38).
2. Insert upper back panel so
that it is sitting on top of the
lower back panel as shown in
(Figure 37). The panel must be
supported until one of the side
panels is mounted in place.
Note: There are two tabs in
the bottom of the upper back
Upper back
panel
Lower back
panel
Left side
panel
Right side
panel
panel that fi t into two slots
on the top of the lower back
panel.
3. Insert fi rst side panel by tilting
the panel into the fi rebox
chamber. Then, slide the panel
until it reaches the fi rebox side
wall. Secure panel by attaching
the side panel clip.
4. Repeat step 3 for the second
side panel.
5. Reinstall burner kit.
Figure 34:
Interior panel set.
Figure 35:
Side panel clip in place.
Figure 36:
Right side panel.
Figure 37:
Upper back panel.
Figure 38:
Lower back panel.