Pacific Energy NEO 1.6 INSERT Installation And Operating Instructions Manual - Full Flue Liner
NE25.ASINS
5055.950AS 110515-24
11
Full Flue Liner
This fireplace insert must be installed with a continuous liner of 150mm diameter extending
from the fireplace insert to the top of the chimney.
1) Measure the chimney height from the top of the existing flue to the floor of the hearth.
This will allow extra length of liner for flashing and rain cap.
2) Feed the stainless steel liner from top of the chimney, through the damper area and into
the fireplace cavity.
3) Attach a stove connector to the bottom of the liner. Attach the NEO 1.6 Insert removable
flue collar to the chimney connector.
Note: To get access to the connector/and removable flue collar through the flue
outlet of the Insert, the baffle must be removed (see Baffle Removal section page
4) Push the Insert into position inside the fireplace and use the rear adjusting legs to level
the Insert.
5) Attach the flue collar to the opening in the top of the insert firebox. Make sure the
ceramic gasket is in place before securing collar. Tighten the anchoring nuts to secure
the collar to the stove.
6) Measure, trim and shape a top flashing to fit the existing chimney flue. Plan for a 30mm
overlap on each side. Place flashing over top of the liner and seat firmly over thechimney.
6) Screw flashing collar to liner. Caulk gap around flashing with RTV silicone.
7) Attach a rain cap to the end of the liner. A storm collar may be used if desired.
The services of a competent or
certified installer are strongly
recommended to install or
commission this installation.
Consult your local Dealer about
relining your fireplace chimney.
Rain Cap
Stainless Steel Flex
Liner
Damper held open or
removed
Storm Collar and Base
Plate or Top Flashing
Fig. # 4