1 model: pl8304ss / pl8blk - outdoor pizza oven without cart assembly and operating instructions 1. This is instruction manual contains important information necessary for the proper assembly and safe use of the appliance. 2. Read and follow all warnings and instructions before assembling and using ...
2 1. Warning and safety information 3 2. Illustrated parts list 6 3. Hardware pack contents 7 4. Exploded view 8 5. Assembly instructions 9 6. Lp gas assembly 11 7. Natural gas conversion instructions 16 8. Operating instructions 22 9. Care and maintenance 24 10. Troubleshooting 31 11. Warranty 33 t...
3 if these instructions are ignored, there is a possibility of a hazardous fire or explosion which could result in physical in injury or property damages! It is your responsibility to assemble, operate and maintain your gas grill properly. Read all warnings and instructions prior to assembling and o...
4 △ ! Never use the grill in windy areas. △ ! Only a 9 kg (20 lb.) lp-gas cylinder is allowed. The cylinder must be constructed and marked in accordance with the specifications for lp gas cylinders of the u.S. Department of transportation (d.O.T.) or the national standard of canada, can/csa-b339, cy...
5 we urge you to read this manual carefully and follow the recommendations enclosed. This will ensure you receive the most enjoyable and trouble-free operation of your new gas grill. We also advise you retain this manual for future reference. Your grill has been designed to operate using only the ga...
6 part number description qty a oven body 1 b smoker box 1 c cooking grate 2 d pizza stone 1 e bottom grill 1 f flame tamer 1 g drip tray 1 h control knob 1 i pvc feet 4 j manifold and regulator 1 2. Illustrated parts list 3..
7 the following list is included inside the pizza oven carton: the following list is included inside the pizza oven carton, and needed when the user is assembling the pizza oven. Phillips head screwdriver 1 pc the following list is included inside the pizza oven carton except for the natural gas hos...
8 no. Part name qty no. Part name qty 1 heat shield pipe 4 27 round temp. Gauge 1 2 oven back heat shield 1 28 left glass fixing bracket 1 3 light assembly 1 29 control panel 1 4 handle buckle 1 30 knob bezel assembly 1 5 gas pipe 1 31 control knob 1 6 chimney assembly 1 32 light switch 1 7 cooking ...
9 before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list. If any part is missing or damaged, do not attempt to assemble the product. Step 1： feet assembly attach 4pcs m5*30 cross recessed cheese head screws and 4pcs ...
10 step 4 ： oven body assembly install cooking grate (part c), bottom grill (part e), a knob, pizza stone (part d), smoker box (part b)and drip tray (part g) as shown. Step 5： your complete pizza oven is now assembled..
11 gas grills that are set to operate with l.P. Gas come with a high capacity hose and regulator assembly. (note: only use the pressure regulator and hose assembly supplied with the grill or a replacement pressure regulator and hose assembly specified by the manufacturer). This assembly is designed ...
12 gas tank must be place vertically. It is unsafe to operate the grill if the gas tank is not vertical. The type i connective coupling (see below pic) supplied with your grill must not be replaced with a different type of grill/tank connection system. Removal will result in loss of warranty, gas le...
13 disconnecting a liquid propane gas (lp gas) tank from your grill: 1. Turn the burner knobs and lp gas tank valve to the full off position. (turn clockwise to close.) 2. Detach the hose and regulator assembly from the lp gas tank valve by turning the quick coupling nut counterclockwise (as shown b...
14 • only a qualified gas supplier should refill the l.P. Tank. • place dust cap on cylinder valve outlet whenever the cylinder is not in use. Only install the type of dust cap on the cylinder valve outlet that is provided with the cylinder valve. Other types of caps or plugs may result in leakage o...
15 if you cannot stop a gas leak, turn off the gas supply and call your local gas company. If necessary, replace the faulty part with the manufacturer’s recommended replacement part. A slight leak could cause a fire. Do not use the grill in garages, breezeways, sheds or any enclosed area. Never oper...
16 before the conversion, make sure all control knobs are in the off position, lp tank valve is closed, and tank is disconnected from regulator and removed from grill. Step 1: open the oven door and remove the two cooking grills, smoker box, pizza stone, bottom grill and flame tamer. Step 2: loosen ...
17 the burner opening must be positioned properly over the valve orifices. Verify whether the burner inlet has been connected to orifice from the bottom of control panel ( as below pic shown). Step 4: use orifice removal tool to remove theφ1.2 lp orifice from the pizza oven. And then use the same to...
18 step 6: put back the two cooking grills, smoker box, pizza stone and base grill into the right position. Step 7: use the 17x19 mm wrench to remove the regulator and then put on the ng hose. Fasten the hose using 17x19 mm wrench. Step 8: use the screw driver to put the conversion screw into the kn...
19 step 10: after finish converting to natural gas, pls attach below label and ng label to the grill. Please remember this is an outdoor gas grill. Many areas of the grill generate extreme heat. We have taken every precaution to protect you from the contact areas. However, it is impossible to isolat...
20 do not return your grill to the store. Never attach an unregulated gas line to the appliance. Connection to an unregulated gas line can cause excessive heat or fire. Verify the type of gas supply to be used, either natural gas (n.G.) or liquid propane (l.P.), and make sure the serial plate agrees...
21 clearance to combustible construction: a minimum of 61 cm (24 inches) from the sides and back must be maintained from the gas grill above and below the cooking surface to adjacent vertical combustible construction. Clearance to non-combustible construction: a minimum of 61 cm (24 inches) clearanc...
22 select a proper location once you have assembled your new oven, find a suitable location for use. Note: the installation of this appliance must conform with local codes or, in the absence of local codes, with either the national fuel gas code, ansi z223.1/nfpa 54, or natural gas and propane insta...
23 remove the bottom grill and pizza stone. Keep your face as far away from the burner surface as possible and pass the match extender to the ports of the main burner tubes. Position the match near the burner ports and push and turn the control knob counterclockwise to the “high” position. After the...
24 keep the ventilation openings of the cylinder enclosure free and clear from debris. Visually check the burners. General cleaning before cleaning, make sure all controls are off and the oven is cool. Always follow label instructions on cleaning products. For routine cleaning, wash with soap and wa...
25 1. Turn off/unplug and allow to cool before replacing bulb (lamp). 2. Bulb (lamp) gets hot quickly! Only contact switch/plug when turning on. 3. Do not touch hot lens, guard, or enclosure. 4. Do not remain in light if skin feels warm. 5. Do not look directly at lighted lamp. 6. Keep lamp away fro...
26 3. Use screw driver to loosen the screw that fix the light assy. 4. Use one hand to hold the metal back part of the light and one handle to hold the front glass cover and then take them apart. Then you can replace the bulb. 5. After replacement, use one hand to hold the metal back part of the lig...
27 6. Use m4*10 screw to fix the light assy. On to the back panel of the oven. 7. Use screw m5*35×4 pcs to fix the back heat shield onto the back panel of the oven. The order is: screw→back heat shield→heat insulation washer→flat washer→oven back panel. 8. Finally, put back the two cooking grills, s...
28 make sure the light switch is on “off” position and power plug is disconnected from power outlet prior to cleaning the glass cover. The light glass cover should not be in contact with water or any other liquid when it is warm. Sudden changes of temperature may cause cracks on glass cover. To ensu...
29 oven door cleaning 1. Loosen the m4*10 screw * 4 pcs that fix the oven door and then take the oven door apart from the oven. 2. Loosen the m4*10 screw * 7 pcs that fix the door exterior and interior, and then loosen the m4*10 screw * 4 pcs that fix the door hinge. Then loosen the shoulder screw t...
30 4. After cleaning, you need to re-assemble the oven door. Put the door interior onto the exterior and make every screw hole in line with each other. Use m4*10 screw * 7 pcs to fix the door interior and exterior. And then use shoulder screw to fix the handle onto the door. Finally, use m4*10 screw...
31 many solutions given here can make your grilling experience safer and more enjoyable. You can also call the customer service department at 1-866-410-0408, 8 a.M. – 5 p.M., pst, monday to friday. Problem possible cause corrective action grill will not light. 1. The ignition wire came off the elect...
32 low heat with the knob in “high” position. 1. Low heat is found in 2. Natural gas models. 2. Ports are blocked. 3. Lp tank has run out. 1. This model is set for 7 in. Natural gas usage. Please check your natural gas supply system to have correct gas pressure. Regulator is not needed for ng model....
33 pacific living inc. Outdoor gas oven limited one (1) year warranty pacific living pizza ovens are covered under manufacturer warranty for one full year from the date of purchase. The warranty is for parts and labor and at the discretion of pacific living the unit will be repaired or replaced unde...
