Packedge s8mpd Quick Start Manual - page 6
6
S8Mpd Quick Start Guide
pakedgedevice&software
inc
pakedgedevice&software
inc.
3. Connect your computer to any of the available ports on the S8Mpd.
4. Configure the switch to an IP address that matches your network. Configuration process is
described in the following sections.
Configuration
There are two ways to complete the initial configuration of the S8Mpd switch:
Using the standard IP address and a web browser
Using a console cable and a terminal emulation program such as PuTTY or HyperTerminal.
Configuring the Switch Using the Web Interface (Windows 7)
1. First you need to configure the PC with IP address 192.168.1.10, and subnet mask
255.255.255.0, by going to the Windows Control Panel, double-clicking Network
Connections and double-clicking the connection of your Network Interface Card (NIC). The
Local Area Connection Properties dialog appears:
Figure 3: Local Area Connection Properties
2. Select Internet Protocol Version 4 (TCP/IPv4) and click Properties. The Internet Protocol (TCP/IP)
dialog appears where you can configure the TCP/IP settings of your PC.