Paddle King Lo Pro Angler Owner's Manual - page 5
Note: There is danger of an electric current in the water near boats linked to shore power.
Important: Do not attach copper, steel, brass, or bronze directly to the aluminum on your pontoon. This may cause
an electrolytic reaction. Use only aluminum or stainless steel or separate dissimilar metals with a gasket.
Tubes:
If an aluminum tube gets punctured, it will need to be fixed and welded by a professional welder. Contact
your dealer for referrals.
Salt Water Use:
Our boats were intended for fresh water use. If plan on using your boat in salt water every day, we
recommend that you contact your dealer for a recommendation on an anti-fouling salt water paint to use on your
tubes. You may want to remove it from the water every month and rinse it down completely with fresh water. Clean
the hardware and spray with a corrosive inhibitor every month. Since salt water also affects the motor, contact your
dealer for additional information.
Deck Hardware and Fittings:
Clean all cleats, rails, and similar equipment periodically with good chrome cleaner
and polish paste wax to prevent any corrosion. Replace any broken or damaged hardware by bolting it through the
deck and use a reinforcing block underneath if there was one originally.
Seat Coverings and Vinyl:
Keep vinyl clean and dry by wiping down after every use and keeping your boats or
seats covered. If seat cushions are wet for a long periods of time, you may want to remove them and dry them out
completely, since water can eventually seep into seams. When necessary, clean the vinyl cushions with a mild
soap and water. Suntan lotion, insect repellants and any other type of chemical can cause stains. Clean vinyl off
as soon as possible if they come in contact with the vinyl.
Canvas and Boat Cover:
Never store canvas when it is still damp. Periodically clean your canvas or boat cover to
remove dirt and dust by wetting the article down completely and scrubbing with a mild soap and soft-bristle brush.
Never use bleach or harsh detergents. Brush the underside of the top. Spray with Lysol or other disinfectant to
prevent mildew. Lubricate zippers with paraffin and snaps with petroleum jelly.
Floor Coverings:
Keep carpet clean by sweeping with a broom or vacuum. Clean when necessary with a diluted
household cleaner and warm water and a scrub brush. Rinse thoroughly and allow to dry completely before
covering or storing.
Tube Maintenance:
Use a commercial hull cleaner and a brush to remove any algae or scum on the tubes. It is
easier to clean when wet. Your dealer may be able to recommend a type of cleaner that works best for your tubes.
IV. Winterization and Storage
By following some simple procedures, you can extend the life of your boat and its equipment. This chapter includes
some general information about storing your boat after the boating season is over.
Indoor storage is ideal, especially in areas where ice and snow accumulate. If storing your boat indoors, make sure
the facility has adequate ventilation. If storing your boat outdoors, cover it with a canvas cover and provide
ventilation to keep the boat from building up moisture. A snap-on mooring cover with center poles can be
purchased from Paddle King or from your Paddle King dealer. This cover is idea for storage.
Before preparing your boat for winter storage, thoroughly check the condition of the boat and its equipment. It is
normally advisable to make sure all repairs are done before storage. It is a good time to perform all annual
maintenance at this time. Please note that damage due to improper storage will void the warranty.
Preparation for storage:
Lifting your boat: The best way to lift your boat out of the water is to load it on your trailer
(see “Trailering” section). If a trailer is not available, arrange to have a marina lift your boat out of the water.
Workers at the marina know the proper way to lift your boat and have the proper equipment available.
Please note: Any “U” bolts on tubes are to be used only for mooring. Attaching lifting lines at these points will
damage the tubes.