Pakedge SW24-GBM Quick Installation Manual - page 9
SW24-GBM QUICK INSTALLATION GUIDE
8
3. Select “Use the following IP Address” and manually type in the IP address and subnet mask into the
provided boxes, as in Figure 4. (Be sure the IP address and subnet mask are on the same subnet as the
SW24-GBM.)
4. Click OK to close the dialog, and then click OK to close the Local Area Connection Properties dialog.
5. Now open a web browser (Internet Explorer, Mozilla and Chrome browsers all work for configuring the
SW24-GBM, but Internet Explorer is preferred)
6. Enter the switch’s default IP address: 192.168.1.201 into the Address Bar and press
7. The default password is blank. Simply click “Apply” to be logged into the web administration portal.
8. In the web administration portal, you will be able to configure, update and reset the SW24-GBM.
Figure 5:
SW24-GBM Web Interface
PLEASE NOTE: Once you
have logged in, you may
use the web interface (Figure
5) to configure the switch
and customize it for your
environment. You may also
refer to the complete product
manual on our website for
advanced configurations.