Quick start guide wk-2-c 802.11ac dual band access point.
2 2 package contents please refer to the installation manual of your product. Wk-2-c • 802.11ac dual band access point • built-in 3×3 internal antennas • powered by poe+ (by poe+ injector or poe+ switch) • 2 lan ports for network extensions system requirements • windows or mac pc with an ethernet in...
3 3 wk-2-c mounting 1 open the release latch and press on the back of the device to swing the wap out from the ceiling or wall bracket, then swing the wap down..
4 4 2 using the supplied template, cut a 9.125” diameter circle at the desired mounting location for your wk-2-c. Route an in-wall ethernet cable through the opening on the back of the wk-2-c housing, then insert the wk-2-c into the ceiling or wall. 3 use a phillips screwdriver to tighten the mounti...
5 5 4 plug the ethernet cable into the wk-2-c, then route the cable cable as shown. (use the optional cable clip, if necessary.) then, swing the wap back into the wk-2-c housing..
6 6 wk-2-c installation with optional pre-construction bracket pre-construction bracket sold separately. 1 place the pre-construction bracket against the bottom of the ceiling studs at the desired mounting location. 2 mark locations for mounting screws. Drill 1/16” pilot holes at marked locations. S...
7 7 powering up the access point the access point can be powered only by poe+. To power up the access point: 1 connect power using a poe+ injector or a poe+ switch. The access point should now be up and running with its default settings. It does not need to be configured to be functional. To make ch...
8 8 logging in to the access point to log in to the access point: 1 connect a computer to the wk-2-c with an ethernet cable. 2 enter 192.168.1.250 into the address bar of your web browser. You should see a login page. 3 in the username box, type pakedge. In the password box, type pakedgea, then clic...
9 9 configuring the access point in this section, you can change the ssid name by applying the security profile that was set up in the security profiles tab. By default, the ssid is pakedge2.4-1 and pakedge5-1. You will have the option to change the wireless name (ssid) and add security profiles by ...
Technical support for technical help: www.Pakedge.Com/portal support@pakedge.Com (650) 385-8703 for non-technical inquires: customerservice@pakedge.Com (650) 385-8701 for regulatory information: www.Pakedge.Com/regulatory doc-00182-a 2016-11-03 ms 11734 s. Election road draper, ut 84020 main: (650) ...
