Palazzetti Ecofire Adagio Installation, User And Maintenance Manual - page 12
38/136
cod. 00 477 2290 - 07/2013 - Palazzetti - PN - Italy
INSTALLATION
“S
EALED
”
SERIES
STOVES
The “Ermetica” series pellet stoves allow the
following possible installation alternatives:
& ducted combustion air using a coaxial pipe to
£ '
consequently no fresh air vent is needed in the
room (Fig. 5.5 A, B=Air intake C, D=Flue gas
outlet);
& connect the stove combustion air intake to the
fresh air opening using a special pipe (Fig. 5.6).
5.5 FLUE GAS EXHAUST
The stove operates with negative pressure in the
! !
gas discharge must be airtight.
The stove must be connected to its own
!
ensuring adequate atmospheric dispersion of the
combustion byproducts.
+£
!!
conditions and bear the CE mark.
+
have a nominal diameter of 8 cm with gaskets (up
to 5 metres in length), or 10 cm with gaskets (for
lengths exceeding 5 metres) (Fig. 5.7).
+!!#
rock wool) or made using double wall steel pipes,
except for the initial vertical section inside the
room.
An initial vertical section measuring a minimum of
exhaust.
There should be at least three changes in direction
at the rear of the stove, using 45 or 90° angle
connectors or ‘T’ connectors.
Use always a ‘T’ connector with inspection cap on
"
It is necessary to connect a pipe at the bottom of the „T“
junction in order to discharge the smoke condensate
#$
The maximum length of horizontal sections is 2-3
¢¢^|#$
¢
+X]+?[+J*
connected to:
& a chimney used by other heat generators
#!$'
& air exhaust systems (range hoods, vents, etc.....)
even if these are ducted.
Shut-off or draught valves must not be used.
Combustion byproducts must be discharged
through the roof.
#
B
B
B
Ø 8 cm
Ø 8 cm
Ø 8 cm
MAX 2 - 3 m
C > 3 - 5%
MAX 2 - 3 m
A
A D
B
C
Fig. 5.7a