Pallas Duo Operating Instructions Manual - 5 Programming
8
5 Programming
1. Programming the time of day
Press the
-
or
+
keys to adjust the time of day per minute. Prolonged holding of either the
-
or
+
keys will accelerate the
changes.
2. Programming the valve
2.1.
Enter the programming mode
Press and hold both of the - and + keys for 5 seconds to enter the programming mode.
2.2.
Change of program and modifications
Press the
key to pass from one stage to the next until leaving the program and returning in service. To use the- or + keys
to modify the programmed values.
The programmed values.
Note: it is necessary to pass through all of the programming stages and to return to service position so that any modifications to
the program are saved.
The first stage of the programming mode corresponds to the system capacity. The capacity is expressed
in US gallons, litres or in m
3
(format US/metric or m
3
). For example : 6500 litres
The second stage allows the adjustment of the time of regeneration. For example : 2 Oclock in the
morning.
The third stage is a calander day overide. (maximum number of days between 2 regenerations). For
example : a regeneration at least every 7 days.
Press the
key to return to the service position. The programming is finished.
3. Initiate a manual regeneration
In the event of prolonged absence, and of non use of your Pallas Duo, it is necessary to initiate a manual regeneration.
There are two ways to initiate a manual regeneration:
1. To press the
key: if an immediate regeneration is programmed, the valve will instantly start the regeneration
2. To press and hold the
key for 5 seconds: - in both cases, a regeneration will start instantantly