Palm 1047ML User Manual - page 656

Palm

®

 T|X

 Handheld

634

Product Regulatory Information

FCC Statement

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: 

(1) This device may not cause harmful interference, and (2) this device must accept any interference received, 

including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant 

to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful 

interference in a residential installation. This equipment generates, uses, and can radiate radio frequency 

energy and, if not installed and used in accordance with the instructions, may cause harmful interference 

to radio communications. However, there is no guarantee that interference will not occur in a particular 

installation. If this equipment does cause harmful interference to radio or television reception, which can be 

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by 

one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

The use of shielded I/O cables is required when connecting this equipment to any and all optional peripheral 

or host devices. Failure to do so may violate FCC rules.

Changes or modifications not covered in this manual must be approved in writing by 

the manufacturer’s Regulatory Engineering Department. Changes or modifications made without written 

approval may void the user’s authority to operate this equipment.

In August 1996, the FCC of the United States with its action in Report and Order FCC 96-326 adopted an 

updated safety standard for human exposure to radio frequency electromagnetic energy emitted by FCC 

regulated transmitters. Those guidelines are consistent with the safety standard previously set by both U.S. 

and international standards bodies. The design of this product complies with the FCC guidelines and these 

international standards.

IMPORTANT

[ ! ]