Pana-Pacific Blue Eagle ll Instruction Manual - page 5
Blue Eagle ll Ultra Noise Cancelling Headset
When the headset is in In-Call Mode, the blue indicator light on the
headset will flash faster, about twice every 2 seconds. You can control the
volume up / down and disconnect the call by using the headset buttons.
Turning the Headset Off and On
• Off – Press and hold the multi-function button on the headset for
about 3 seconds until you hear a long beep in the earphone. The
blue indicator light on the headset will stop flashing. The headset
is now off.
• On – Press and hold the multi-function button on the headset for
about 3 seconds until you hear 2 short beeps in the earpiece. The
blue indicator light on the headset will begin flashing every 4
seconds. The headset is now on and in Idle Mode.
PAIRING
Note: you must pair the Blue Eagle II headset with your other Bluetooth
device before first use.
Before Pairing: Turn the Headset Off
If the blue indicator light on the headset is flashing (you may need to wait
5 seconds to see it), then you must turn the headset off before pairing.
Check the User’s Manual for your other Bluetooth device for instructions
or information about pairing preparation for those products.
Pair the Blue Eagle II Headset with another Bluetooth Device
Examples: Bluetooth-enabled phone, Bluetooth computer or computer
Bluetooth dongle, etc.,
Be sure the Blue Eagle II headset is in the OFF position and is not
connected to a power adapter before pairing. (See “Before Pairing”
above)
IMPORTANT: Consult the Owner’s Manual of your other Bluetooth device
(or the manufacturer) for information about the device’s pairing procedure.
1. Turn off all other Bluetooth devices or keep them at least 50 feet
away.
2. Position the Blue Eagle II headset and your other Bluetooth device
no more than 3 feet apart.