Panamorph ATH2 Owner's Manual - Lens Sled Operation
ATH2 Owner’s Manual
7
Lens Sled Operation
The status LED indicator behind the plastic window on the ATH2 will flash three times when the unit is
powered ON, and flash when any remote button is pressed. When in standby the LED is off. Once turned
ON, the unit remains in the ON state, even if the power fails and is reinstated.
Buttons:
OFF – Puts the ATH2 in standby mode.
ON –Turns the ATH2 ON.
LENS OUT – Moves to the LENS OUT position.
LENS IN –Moves to the LENS IN position.
PANEL OFF – Switches the logo back light and status LED
off.
PANEL ON – Switches the logo back light and status LED
on.
SLOW – Sets the acceleration/deceleration and maximum
speed for slow (low inertia) traversal.
FAST – Sets the acceleration/deceleration and maximum
speed for rapid traversal.
Note: If LENS IN does not position the lens to the correct
side of the mechanism, see Chapter5 (middle of page 8) to
reverse orientation.
Users of Pronto compatible devices may download an IR
code hex file from the following URL:
The Panamorph ATH2 will appear in the FILES section of
the website as Panamorph M380.
©
Panamorph Inc January 2009 – All rights reserved
Page
10