Panamorph ATH2 Owner's Manual - Theater
ATH2 Owner’s Manual
3) Attach anamorphic lens to bracket
Attach the UH480 lens to the bracket using the lens knobs supplied with the lens. Adjust the anamorphic
lens vertically for correct alignment. See the instructions accompanying the UH480 attachment kit for fine
tuning the lens position and screen image. Instructions are downloadable from http://www.panamorph.com.
When the image is correct, tighten the knobs against the bracket. Test run LENS IN and LENS OUT using
the remote. It is important to note that the lens is vertically oriented to the
projected beam
coming out of
the bottom half of the projector lens (assuming ceiling mount). Usually, the top of the anamorphic lens
will lie somewhere near the center of the projector lens as shown below.
Note
alignment of
top of lens
Lens knob
4) Configure Operating Speed (optional)
The lens sled has two operating speed modes – FAST and SLOW. FAST is the default from the factory,
and is ideal under most circumstances. The slow mode reduces the forces exerted by the lens on the
mounting system by accelerating and decelerating very slowly, and by limiting the top speed of the lens as
it traverses the sled. Some users set the speed to SLOW when used in conjunction with screen masking
systems to synchronize mask traversal time to sled traversal time.
CONGRATULATIONS!!!! YOU ARE NOW READY TO
ENJOY FULL WIDESCREEN CINEMA IN YOUR HOME
THEATER
.
©
Panamorph Inc January 2009 – All rights reserved
Page
9