Panasonic KX-TG454SK Operating Instructions Manual - Alarm
*2 This menu is not displayed when scrolling through the display menus. It is only available in
direct command code.
*3 KX-TGE270 series: page 3
*4 When the cellular line only mode is turned on, these menus are not displayed (page 20).
*5 After the Bluetooth device is paired, the device name is displayed.
*6 For CELL 1
*7 For CELL 2
*8 The preset melodies in this product are used with permission of © 2012 Copyrights Vision
Inc.
*9 The preset melodies in this product are used with the following permission:
– “Tone 1” and “Tone 2”: © 2013 Copyrights Vision Inc.
– “Tone 3” - “Melody 10”: © 2012 Copyrights Vision Inc.
*10 This feature allows the unit to automatically adjust the date and time each time caller
information including date and time is received.
To turn this feature on, select “Caller ID auto”. To turn this feature off, select
“Manual”. (Caller ID subscribers only)
To use this feature, set the date and time first (page 16).
*11 If you subscribe to a distinctive ring service (such as IDENTA-RING), select a tone (tone 1 or
2). If you select a melody, you cannot distinguish lines by their ringers.
*12 This tone lets you know when you receive an outside call while you are on another line or an
intercom call. If you select “On”, the tone sounds 2 times.
*13 This setting is available when you have the key detector (KX-TGA20). Read the installation
manual for more information on the key detector.
*14 For models with supplied key detectors, the display shows “1: Detector1”.
*15 If you register 2 or more key detectors.
*16 If you have 2 or more key detectors.
*17 If you subscribe to a Caller ID service and want to view the caller’s information after lifting up
the handset to answer a call, turn off this feature.
*18 The flash time depends on your telephone exchange or host PBX. Contact your PBX
supplier if necessary. The setting should stay at “700 ms” unless pressing MFLASHN fails to
pick up the waiting call.
*19 Generally, the line mode setting should not be changed. This setting automatically maintains
receiver volume at the proper level depending on the current telephone line condition. Set
the line mode to “A” if telephone line condition is not good.
Alarm
An alarm sounds at the set time for 1 minute
and is repeated 5 times at 5 minute intervals
(snooze function). A text memo can also be
displayed for the alarm. A total of 3 separate
alarm times can be programmed for each
handset. You can set one of 3 different alarm
options (once, daily, or weekly) for each alarm
time.
Important:
R Make sure the unit’s date and time setting
is correct (page 16).
1
MMENUN#720
2
Select an alarm by pressing 1 to 3. a
MSELECTN
3
MbN: Select the desired alarm option. a
MSELECTN
“Off”
Turns alarm off. Go to step 10.
“Once”
An alarm sounds once at the set time.
“Daily”
An alarm sounds daily at the set time.
Go to step 5.
44
For assistance, please visit http://www.panasonic.com/help
Programming
TGE26x_27x(en)_1216_ver041.pdf 44
TGE26x_27x(en)_1216_ver041.pdf 44
2013/12/16 19:32:29
2013/12/16 19:32:29