Panasonic KX-TG454SK Operating Instructions Manual - Advanced New Message
Key
Operation
8
Turn answering system on
MPAUSEN
Pause message
*2
9 or
MSTOPN
Stop recording
Stop playback
0
Turn answering system off
*4
*3
Erase currently playing
message
*5
Erase all messages
*6
Reset to a pre-recorded
greeting message
*1 If pressed within the first 5 seconds of a
message, the previous message is
played.
*2 To resume playback:
MbN: “Playback” a MSELECTN
*3 You can also erase as follows:
MPAUSEN a MbN: “Erase” a
MSELECTN a MbN: “Yes” a MSELECTN
Calling back (Caller ID subscribers
only)
n
Using a cellular line:
1
Press MPAUSEN during playback.
2
MbN: “Call back (Cell)” a
MSELECTN
R The unit starts dialing when:
– only 1 cellular phone is paired.
– a specific line is set to make
cellular calls (page 21).
3
MbN: Select the desired cellular phone.
a MSELECTN
n
Using the landline:
1
Press MPAUSEN during playback.
2
MbN: “Call back” a MSELECTN
Editing the number before calling back
1
Press MPAUSEN during playback.
2
MbN: “Edit & Call” a MSELECTN
3
Press MEDITN repeatedly until the phone
number is shown in the desired format
(page 50). a M
N
R To call back using a cellular line,
continue from step 2, “Making cellular
calls”, page 22.
Erasing all messages
1
MMENUN#325
2
MbN: “Yes” a MSELECTN a MOFFN
Advanced new message
alerting features
Audible message alert
This feature allows the base unit to beep to
inform you of a new message arrival when
new messages are recorded. The base unit
beeps 2 times every minute until you listen to
the messages, if the “Base unit beep”
setting is turned on. The default setting is
“Off”.
1
MMENUN#339
2
MbN: Select the desired setting. a
MSAVEN a MOFFN
New message alert by a call
This feature allows you to receive a
notification by phone when new messages are
recorded. The base unit calls a phone number
you specify. You can then operate the
answering system remotely to listen to the
new message.
To use this feature, you must:
– store a phone number to which the unit
makes the call to.
– turn on the new message alert setting.
After you answer the new message alert call,
you can listen to messages from that call
(page 59).
Important:
R A new message alert is stopped 1 minute
after the unit starts to call. The unit will not
retry the call even if the call is not answered.
58
For assistance, please visit http://www.panasonic.com/help
Answering System for Landline
TGE26x_27x(en)_1216_ver041.pdf 58
TGE26x_27x(en)_1216_ver041.pdf 58
2013/12/16 19:32:30
2013/12/16 19:32:30