PLX Luxor User Manual - page 8
PLX
devices inc.
www.plxdevices.com
8
Changing Your Battery
1. Before changing your Luxor battery, always make sure that there is no moisture present on or around
your Luxor unit.
2. Unscrew the tail cap seal and remove the tail cap.
3. Disconnect the battery connec-
tor and remove the battery.
4. Slide your new Luxor battery
into the battery compartment
and connect the battery.
NOTE: Be sure that your bat-
tery connector is inserted with
the correct orientation.
5. Place the tail cap back into
position, making sure that it is
correctly oriented by aligning
the micro USB opening with
the micro USB port.
6. While applying pressure on the
tail cap, screw the tail cap seal
back on. Be sure that the tail
cap seal is completely screwed
onto the body of your Luxor.
NOTE: If your Luxor will
not charge aft er replacing the
battery, confi rm that the tail cap is aligned properly and the tail cap
seal is completely screwed onto the body of your Luxor. If the tail
cap is misaligned or the tail cap seal is not screwed on completely,
your micro USB cable will be unable to be inserted completely, preventing your Luxor from registering a
charge.
Charging Your Luxor
1. Insert the USB Male A end of your charging
cable into a USB power source.
2. Unscrew the tail cap seal and remove the tail
cap.
3. Connect the Micro USB end of your
charging cable into Luxor’s Micro USB port.
NOTE: Luxor will still charge if it is off or
locked.