PNI B3000 Manual - Some Points To Remember:
Some points to remember:
Battery Power.
For both units, receiver and transmitter:
1) Use exclusively AAA size 1.5V alkaline batteries ( 6pcs required, but not included)
2) Unscrew the screw of the battery compartment, take the lid off and insert the batteries
with right polarity.
3) Put the lid back, screw in the screw and check that it is perfectly closed.
4) Switch the unit on and check that the power LED is on and in green.
Electricity power.
The Baby monitor can operate by batteries as well as by power adaptors.
1) Insert the power adaptor into AC outlet.
2) If your outlet has a security switch, make sure it is on.
3) Switch the unit on and check that the power LED is on and in green.
Low battery indicator and Out of range alert :
When battery becomes weak, the power LEDs of the units turn into red color . It is time to
replace for a new battery. So for long hours use, it is advisable to use power adaptor.
If the receiver is too far from transmitter, the system cannot work properly. You will hear
“ beep beep” sound which is Out of range alert. Meanwhile the volume LEDs flash . In this
case, you have to put the two units nearer to each other.
If the receiver is too close to the transmitter, an acoustic feedback might be heard. In this
case, you have to put the two units farther from each other, or turn down the volume of the
receiver.
A background noise from the receiver may signal that the batteries are exhausting and they
need to be replaced. Check that if power LED turns into orange color, it means they need to
be replaced.
-8-