PocketWizard PowerMC2 Quick Manual - To Use Your Powermc2:
1. Connect the PowerMC2 to your Einstein
™
E640 Flash
via the remote port, then power on the flash.
2. Select the Channel and Zone A, B, or C via the E640’s
LCD.
3. Set up your PocketWizard transmitter and
take pictures normally.
4. Adjust the camera’s Flash Exposure Compensation (FEC) to
adjust the power of your remote flash. See the Basic
Power Control section for more information about FEC.
Make sure all your radios are set to the same
PocketWizard channel.
The Status LED blinks
green
every few seconds to
indicate normal operation. It will blink
red
in sync
with a trigger.
Momentarily pressing TEST will test trigger the flash.
Your PowerMC2 needs to be on the same channel as your
transmitter. Channels can be set via the E640’s built-in LCD. The PowerMC2 is capable of receiving on either
ControlTL Channels for use with ControlTL radios like the MiniTT1 and FlexTT5 or Standard Channels for triggering
with the PlusX, Plus III, Plus II, and MultiMAX.
To set the channel, press the Einstein’s
™
FUNCTION button until the Channel selection box is highlighted and
then change channels with the ADJUST buttons. Press the FUNCTION button again to specify a zone. When using
ControlTL Channels or Standard Channels 17-32, you can specify zone A, B, or C.