PocketWizard PowerMC2 Quick Manual - page 9
To change the values used for the center point, turn off your transmitter then turn it back on and follow these steps
again. See the PowerTracking Tab in the PocketWizard Utility section below for more information.
IMPORTANT NOTE:
Shooting in Shutter Priority/Tv, Program, Full Auto, or shooting quickly or making rapid exposure
changes is not recommended. The flash values may change rapidly and your remote flash may not be able to keep up.
Honor your flash’s ready wait time or “dump” as necessary.
FEC NOTE: Flash Exposure Compensation (FEC) can be set in many places and all values are added together.
FEC can be set:
• On the Power Dials of the AC3 ZoneController
• On the camera for all zones except AC3 Manual zones
• For transmitting radios, the PocketWizard Utility can adjust the PowerTracking center point for ISO and aperture
which affects all zones
• For a PowerMC2, the PocketWizard Utility can adjust FEC for the directly connected flash on the PowerTracking tab
If the combined FEC settings are more or less than your flash’s capabilities, then the flash will operate at maximum or
minimum output accordingly.