Protherm PTCP User Manual - page 17
INSSTCP0408
You must proceed as follows:
1. Press down the button corresponding to the day to view (but-
tons Mon to Sun). When the selected day is displayed, the
SET icon and period number blink.
2. Choose the period number (1 to 2) to view using the + or - but-
ton. For each period, the hour and set point are displayed. You
can also press down the Mode button to switch to period 2. If
you press down the Mode button when period 2 is displayed,
you exit the View mode.
At any time, you can exit the View mode using one of these
3 methods.
1- Press down the button of the day you are viewing.
2- Press down another day to view it.
3- Press down the Exit button.
If you do not press down any button during 1 minute, the ther-
mostat quits the view mode. At any time, it is possible to change
the day to be viewed by pressing down the desired day button.
Ambient/Floor Mode
To switch from the Ambient mode to the Floor mode, or con-
versely, press down the A/F button (when you are not in any ad-
justment mode). Then, the temperature set point will become the
same as the Floor or Ambient mode temperature, as applicable.
However, if a set point is programmed for the current period, it
will take this value.
Sensor Selection
If you want to use the PTCP thermostat of Protherm with a
temperature sensor already installed in the floor (other than the
sensor supplied with this thermostat), you must contact the Pro-
therm customer service to validate the compatibility between
the sensor and the thermostat. You must know the serial number
and name of the installed sensor.