PRTC Digital TV Manual - page 14
PRTC Digital TV Ser vice
Technical Support (843) 538-5481
www.PRTC.coop
PRTC Digital TV Ser vice
24
25
5. If you want to limit your series recording to first run only episodes,
select
FIRST RUN ONLY
under
SHOW TYPE.
The default setting is to record every instance.
6. If you think that the episodes may run long, add extra time to the end of the program by selecting
STOP RECORDING.
Press
and select a time.
Note: Your PRTC Whole Home DVR will not adjust if a program’s schedule changes unexpectedly. However,
planned schedule changes, such as a series moving from 7:00pm to 7:30pm for one week, will be detected by your
DVR and the episode will be recorded in its entirety.
Schedule A Single Recording By Channel, Time And Date
1. Press
RECORDED TV
on your remote. Or you can press , and use the right arrow key
to
select
RECORDED TV
.
2. Use the Arrow Keys to select
ADD RECORDING
and press
.
3. Select
CHANNEL AND TIME
and press
. The
MANUAL RECORD
screen will then appear.
4. Use the Arrow Keys to fill in the fields on the
MANUAL RECORD
screen.
t:PVDBOFMFDUUPLFFQUIFSFDPSEFEQSPHSBNVOUJMZPVEFMFUFJUPSZPVDBOBMMPXZPVS
Whole Home DVR to delete it when it is time to make room for new recordings.
5. Select
RECORD
and press
to schedule the recording.
SOLVE CONFLICTS IN RECORDING SCHEDULES
Your PRTC Whole Home DVR can record up to 2 programs at the same time. If you try to record a
third program, a
RECORDING CONFLICT
screen will appear.
Solve Single Program Conflicts
t5PSFDPSEUIFOFXQSPHSBN TFMFDUJUGSPNUIFNFOVPOUIF
RECORDING CONFLICT
screen and press
.
t5PLFFQXIBUXBTBMSFBEZTDIFEVMFEBOEDBODFMUIFOFXSFDPSEJOH TFMFDUUIFQSFWJPVTMZTDIFEVMFE
program and press
.
Solve Series Conflicts
t5PSFDPSEBMMFQJTPEFTPGUIFOFXTFSJFTJOTUFBEPGBQSFWJPVTMZTDIFEVMFETFSJFT TFMFDU
RECORD
ALL EPISODES OF NEW SERIES
from the
RECORDING CONFLICT
screen and press
.
t*GZPVEPOUXBOUUPSFDPSEFQJTPEFTUIBUDPOnJDUXJUIZPVSQSFWJPVTMZTDIFEVMFESFDPSEJOHT TFMFDU
RECORD ONLY WHEN NO CONFLICT OCCURS
and press
.
Record An Overridden Program
1. Press
. Use the Arrow Keys to navigate to the program that has been overridden (indicated in
the guide by a crossed-out red dot). Press
.