PS Audio PerfectWave Quick Start Manual - page 2
Introduction II
4826 Sterling Drive, Boulder, CO 80301 PH: 720.406.8946 FX: 720.406.8967
Bridge Installation
PerfectWave Bridge Installation Instructions
Turn off the DAC using the power switch on the rear of the unit
Using a Phillips screwdriver (#1 tip), remove the two screws holding the
blank panel over the expansion slot on the rear of the PerfectWave DAC.
Retain the screws to hold the Bridge card in place later.
Follow the instructions on the bag of the disposable wrist strap included
in the box. Connect the alligator clip to a suitable earth ground.
4
Remove the PerfectWave Bridge printed circuit board assembly from the
ESD bag.
Insert the Bridge card into the expansion slot. Slide the board in the rail
guides. You will feel some resistance when the connector mates with the
fingers on the front of the Bridge card. Press firmly until the surface of
the Bridge card back panel contacts the back of the DAC.
1
2
3
5