PS Audio PerfectWave Quick Start Manual - page 4
Introduction IV
4826 Sterling Drive, Boulder, CO 80301 PH: 720.406.8946 FX: 720.406.8967
Bridge Installation
11
Connect an Ethernet cable from a network switch, router, or hub to the
Ethernet port on the Bridge card back panel.
To view the owners manual Online:
http://www.psaudio.com/ps/manuals
To have one sent to you:
Email customerservice@psaudio.com
Phone 720.406.8946
This Accessory, when properly installed in a Perfect Wave DAC,
complies with all relevant CE requirements.
Check to see if the Bridge requires a firmware update. To do this you must be
connected to the Internet. Once connected, go to the Input Select screen on
the PWD’s touch screen. On the Media Bridge input select choice, touch the
green edit icon on the right hand side. This brings you to the Bridge setup
page where you can touch the option to upgrade the firmware. Once upgrad-
ing DO NOT REMOVE POWER WHILE THE BRIDGE IS UPDATING.