PS Audio PerfectWave Quick Start Manual - page 3
Introduction III
PS Audio International, Inc. All rights reserved
Quick Start Guide
Reinstall the screws to hold the Bridge card in place.
6
You may now remove the wrist strap.
7
Insert the SD card into the slot on the back of the DAC . When pressed
all the way it will hold itself in. Do not force it. It should slide easily if
inserted properly.
Note: This SD card plugs
into the socket with the gold
contacts facing up. Make
sure the SD card has the gold
contacts facing up, or the
socket could be damaged.
9
Verify that the tab on the side of the SD card from the Bridge shipping
box is in the unlocked position
– towards the top
8
Turn on the power to the DAC. You should observe the logo light button
on the front panel of the DAC blinking. This will take approximately 30
seconds. When the blinking stops you will see the initialize screen on
display. The DAC should power up normally. It is now updated with the
software necessary to run the Bridge.
10