Q Acoustics M2 Manual - page 15
15
a. Power
Press this button to turn the Unit STANDBY ON/OFF.
b. Source select
Press this button to manually select the audio input source.
The status LED will change colour accordingly.
Important Note: When the Source button is used, the Unit
will stay on the selected source and disable the Intelligent Pre-
Amplifier (IPA) automatic source selection. IPA functions will be
reactivated after the Unit has been put in STANDBY.
c. Volume Up / Down
Press VOL + to increase the volume. Press VOL – to reduce
the volume.
d. Mute
Press this button once to MUTE the Unit. Status LED will
SLOW FLASH to indicate MUTE. Press this button again to
un-mute the Unit.
Please Note: Long press of Mute will also put the Unit into
STANDBY.
e. EQ
Short press the EQ button to toggle MoviEQ
™
On and Off. If
the Yellow LED flashes and remains on, MoviEQ
™
is On.
Caution: When replacing the lithium battery in the remote, make sure that the replacement battery is
inserted with the correct polarity. Place the battery so that the positive (+) side faces up with the tray held so
the surface with the dot and (+) is facing up.
Remote Control battery replacement
a. Push small tab
toward battery slot.
b. Pull battery
drawer out.
c. Insert battery
with “+” side up
and slide drawer
back into remote.
d. Slide drawer
back into remote.
Caution: Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent battery type (CR2025)
Warning: Do not expose batteries to excessive heat such as direct sunlight, fire or the like.
Dispose of dead batteries in accordance with local regulations.
4. Remote control
a
b
c
d
e