Q-See CENTRAL MANAGEMENT User Manual - page 22
42
43
If the first three segments of the IP address are not the same as that of the computer you are
using, then you will need to modify the address. Right-click and then select Network Setup
which will open a window allowing you to change the IP address.
On Q-See brand IP cameras, the default user name is
admin and the default password is
123456. Please check your camera’s manual for more information.
IP TOOL
APPENDIX 2
IP Tool is not part of CMS, but a separate program that was installed at
the same time as part of the package. The shortcut icon to this program
can be found on your desktop. You do not need to have CMS running in
order to run IP Tool.
This program is intended for advanced users who need the ability to
determine or change IP addresses on networked DVRs and cameras. It
can also be used to upgrade the firmware on a connected IP camera.
When you launch IP Tool by clicking on its
icon, it will look for other devices on the
same network as the computer running the
program and it will populate the list.
You can upgrade the software and kernel of
an IP camera by downloading the required
files and then right-clicking on the camera
from the list and then selecting the desired
action.
CAUTION!
When upgrading the software or kernel on a connected camera
do not disconnect either the device or the PC before receiving the Update
Success message or you could damage your camera.
Once you have received the Update Success! message, click OK and the device will restart
QUESTIONS OR COMMENTS? CONTACT US
24/7 TECHNICAL RESOURCES,
KNOWLEDGE BASE AND MORE
www.Q-See.com/Support